This article will show you how to stop wasting your money on generators and still have electricity using copper wire and a plug.
Have you been looking for a way to get your house lighted up for 24hrs, then you’re at the right place. I will gladly show you step to step ways in which you can stop wasting your money by using just Copper Wire and Plug with some accessories to light up your house whenever there is no light.
Firstly, you need to understand how generator works, generator changes over mechanical energy into electrical energy and that’s why it gives us light whenever we pull it on.
Normally, issues of electricity in Nigeria is a major problem in which some states, communities and environments face. Though some people have resulted to having their own power supply themselves by purchasing a generator which they have to refuel.
In this article I will show you how you can utilize copper wire and plug to help you light up your bulb.
For this who might want to know the reason why this method is very effective, I have listed some points down there.
1. It’s not expensive, you can’t even spend much while getting the materials.
2. It’s not difficult to set up if you follow the instructions.
3. It doesn’t have any risk, and it’s not hazardous.
4. It can run for more than 1 year constant.
5. It doesn’t cause contamination or pollution.
Please I will beg you not to be stingy, share this valuable article with everybody around you and let all of us appreciate this chance. With this, you are free form the issue of electricity until the end of time.
Things you need to get your 100% electricity;
(1) two fittings of a similar size, (2) a copper wire, (3) a glue, (4) a level wooden plyboard, (5) a Lamp holder, (6) welding iron, and (7) magnet.
Steps to be free from darkness in your home.
- Get your plugs and place the plywood on the ground or flat surface, and then use your glue to hold the two plugs on the board.
- Use the copper wire to make a ring shape by rapping it over a biro, much the same as I have done in the image beneath.
- Once you’re done with the coiling then, sold it to the plug.
-
Now, all you have to do is to get your lamp holder and connect the other terminal of the plug to it just like I did in the picture below..
- For the best outcome I will urge you to utilize a big size magnet cause the greater it is, the better for you. After you have your magnet, at that point place the magnet in the middle of the two attachments making it to contact the different sides of the fittings, as demonstrated as follows.
Note this can empower you to charge your telephone, power bulb, utilize different apparatuses with 220V or underneath. To put it off, simply eliminate the magnet and the light will go off.
Now you’re free from the issue of “No light” in your house. Please make sure you follow the instructions and guidelines which I listed above. If you’re confused at any point, I will right here waiting for you to pop up your complain or confusion. Also if you’re at any point not getting the steps, just take a look at those images which I made available, so you can also have an effective outcome. However I want to further implore you to make more than one and share it with your families and friends. Let’s them also enjoy from this opportunity. Don’t forget to hit the follow button up there to keep updated and also share your experience after you might have finished making your own electricity.
For those of you who might want to teach your younger ones, make sure that you supervise them and don’t allow them do it on there own.